Monster Go-DJ Betriebsanweisung PDF herunterladen (Seite 102)

Monster® GO-DJ™ | Instruction Manual | Page 102

Firmware

Firmware Update

You can update the firmware for the GO-DJ by following these directions:

● Download the latest firmware from the GO-DJ official WEB site

(www.monsterGO-DJ.com).

● Connect the GO-DJ to a computer using the USB cable.

● Place the firmware update file on the internal drive (GO-DJ Drive) or SD card.

● Disconnect the GO-DJ from the computer.

● From the SYSTEM menu, slide the UPDATE switch.

Mandatory Firmware Update

If it is impossible to update the firmware from the SYSTEM menu, please run a

mandatory firmware update using the Firmware Recovery Menu. The Recovery Menu

starts when corruption of a firmware file is detected, and you can also manually start it

by following the steps below:

Preparation for Mandatory Firmware Update

● Download the latest firmware from the GO-DJ official WEB site

(www.monsterGODJ.com).

● Place the file to an SD card using an SD card writer.

● Insert the SD card to the SD card slot of the GO-DJ.

Starting the Recovery Menu

● Remove the USB cable if connected.

● Press the RESET button located at the back side of the GO-DJ using a pointed

object such as pen.

● Hold VOLUME-A, FX-LEVEL, VOLUME-B knobs down together and turn the GO-

DJ on simultaneously.

● When a firmware update screen shows, move the crossfader from the left to the

right. If the crossfader is not moved correctly from the left to the right within 10

seconds, the GO-DJ will attempt to boot normally.

1 2 ... 97 98 99 100 101 102 103 104

Keine Kommentare

Monster Go-DJ Betriebsanweisung Seite 102